EXSYS EX-48052 Specifikace

Procházejte online nebo si stáhněte Specifikace pro Karty / adaptéry rozhraní EXSYS EX-48052. EXSYS EX-48052 Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 6
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
1
Congratulation on your purchasing this high performance Mini PCI
Express (Mini PCIe) RS422/485 serial card. The card is high speed PCI
Express bus based and plug-and-play compliant. Both its enhanced
serial ports (256-byte deep FIFO) are jumper-configurable for RS422,
4-wire RS485 and 2-wire RS485 modes.
Features:
Full x1 Mini PCI Express Throughput, 250Mbytes/sec
Fully Compliant with PCI Express Base Specifications, Revision 1.1
Supports RS485 Auto Transceiver Turn Around by Unique Featured
ATTA
TM
Hardware
Supports 2 DB9-male Connectors over Flat Cables
Support 4-wire RS422/485 and 2-wire RS485 Modes
Supports RS422/485 Speed up to 921.6Kpbs
9-bit Data Framing, as well as 5,6,7 and 8bits
Supports Win2000, XP, 2003, 2008, Vista, Win 7 and Linux
EX-48052
2S RS422/485 Mini PCIe Card
1. Introduction
2. Board Layout
J3: S2, 2’nd
RS422/485 port
J2: S1, 1’st
RS422/485 port
JP1: S1 mode
settings
Mini PCIe
golden
fingers
Pin #1
Pin #1
Pin #1
JP2: S2 mode
settings
J5: factory use
only, do not
install any jumper
JP3: S1
Terminator
Enable/Disable
JP4: S2
Terminator
Enable/Disable
Zobrazit stránku 0
1 2 3 4 5 6

Shrnutí obsahu

Strany 1 - EX-48052

1 Congratulation on your purchasing this high performance Mini PCI Express (Mini PCIe) RS422/485 serial card. The card is high speed PCI E

Strany 2 - 3. Jumper Settings

2S RS422/485 Mini PCIe Card 2 There are 2 sets of the jumpers to set the settings for port 1 (S1) and port 2 (S2) respectively.  Mode Selectio

Strany 3

2S RS422/485 Mini PCIe Card 3 Termination Resistor Enabled 1. Remove the Mini PCIe card from its protective antistatic pack

Strany 4 - 5. Software Installation

2S RS422/485 Mini PCIe Card 4 To install the Windows drivers, there are two methods, one is to run the setup utility (StnSetup.exe) in each co

Strany 5 - NC = No connection

2S RS422/485 Mini PCIe Card 5 In some cases, you may want to uninstall the drivers. To remove the drivers that already installed for Windows,

Strany 6 - 2S RS422/485 Mini PCIe Card

2S RS422/485 Mini PCIe Card 6 RS485 (2-wire) Cable Wiring: Power requirements: 5V DC, 450mA (max) Operating temp.: 0 to 558C (32 to 131

Komentáře k této Příručce

Žádné komentáře